Gelmoment with Lana

How to Use GelMoment™ Gel Polish

For best results follow these instructions:

1.Nail tips should be smooth; if necessary use a nail file.

2.Buff the nail surface well, including the corners. Only buff, but do not polish or shine. The objective is to remove any oils present at the surface of the nail, as they can inhibit the adhesion of the gel.

3.Wipe the nail clean with GelMoment™ nail cleanser. Make sure the nail is clean and dry before applying the polish.

4.Shake the bottle gently before use. Heavy shaking can produce air bubbles.

5.Apply a thin coat of GelMoment™ as you would any other nail polish. Be careful not to get any gel on the cuticles or the skin, as this might cause the polish to peel.

6.For best results apply polish over the nail tips too.

7.Cure one or two fingers at a time for 60 seconds under the GelMoment™ LED light, or until light switches off automatically.

8.Should you wish to add a second coat follow steps 5 through 7. To remove the Gel, simply use the GelMoment™ remover pads. Tear across the dotted line and place your nail inside the pouch, underneath the moist pad. Remove the protective plastic strip on the outer side of the pouch to reveal the sticky tape below. This facilitates the ability to tightly wrap the pouch around the nail. Leave inside between 5-10 minutes (depending on your nail type) and remove. Use the GelMoment™ Cuticle Pusher to eliminate remaining residue.